DIY 802 field coil drivers may be a reality!!

[mah]

mah,

I am plenty credible. And I offered sound and credible advice. Who are you, who probably has zero field coil listening experience, to contend that my comments are ill advised?? Me, and my closest of audio friends have direct experience with hundreds of such field coil drivers, over many years and many venues.

I was very clear in what I stated, that the coils buck each other. Everyone hears it, but not everyone recognizes what they are hearing.

This is just my opinion. I am free to state it up here.

No rigid theoretical proof, ( which may or may not be correct ), is needed. The proof of the pudding ......is in the eating.

You, and others, are welcome to have a different opinion, but it would be much more credible to me and others, if you had field coil experience..

This of little consequence to me. I am happily using an 802D, remagnetized by GPA in 2015, as the top-end on A7-800s. My system's wiring, and amplification, is at a level that very much pleases me.

This is an open Forum where we can share our listening experiences, hopefully for the betterment of all. Each individual reader has the mental capability to discern who or what ideas they prefer to follow in any audio discussion, ....it is a right we all have.

Now, for a fifth time, lets get back to the idea that "we two" do not post after each other in the same thread. Its a waste of bandwidth. Anyone can see that is needed. Are you willing to address that ??

Jeff Medwin.....Low Ohms.

LowOhms,

You make an appeal based on a call for openness and then expect me to forgo that openness because you don't like some of my comments. Huh?

Just take responsibility for what you say in public( i.e. the internet) and let this thread(and Forum) return to its original purpose.

Don't try to self-interestedly censor me again!!


Be very careful and relative, legally, with what you say in any reply.